Husqvarna Rider 316T/s AWD Workshop Manual page 56

• Remove the circlip.
• Pull o the wheel and hub from the axle.
• Take hand of the key, spacer sleeve and
washers, keep track of the number of
washers, can vary between sides.
4. Free the front speed adjustment link from the
front axle.
• Check in which hole the adjustment
link is attached (normally the top hole).
5. Drain the oil if necessary, two plugs.
6. Undo the hydraulic pipes from
underneath the front axle. Fit protective
plugs. A small amount of oil may leak out
even if the front axle has not been drained.
7. Remove the front left wing.
56
English-
REPAIR INSTRUCTIONS
Circlip
Adjustment link
Oil drain
Hydraulic pipe, bottom
8009-825
8042-121
8009-631
8009-623