Ignition And Starter Switch; Main Fuses; Checking Safety System - Husqvarna Rider 316T/s AWD Workshop Manual

ignition and Starter Switch

1. Loosen the right wing cover.
2. Remove the inner protective plate on the
lever carrier.
3. Unplug the connector from the ignition
switch by pulling straight down.
4. Remove the ignition key and the rubber
seal.
5. Remove the nut and the ignition switch.
Assemble in reverse order. Make sure the
connector goes into the right position (click
lock).

Main Fuses

The main fuse is located in a loose holder
under the lid of the battery box in front of the
battery.
Type: Spade fuse, 15 A.
Do not use any other fuse when changing.
A blown fuse is indicated by a burnt link. Pull
the fuse from the holder when replacing it.
The fuse is intended to protect the electrical
system. If it blows again shortly after
replacement, it is due to a short circuit, which
must be fixed before the machine can be put
into operation again.

Checking Safety System

The ride-on mower is equipped with a safety
system that prevents starting or driving in the
following conditions.
It should be possible to start the engine only when:
• The cutting deck is raised and the parking
brake is on.
The engine should stop when:
• The cutting deck is lowered and the driver gets
out of the seat.
• The cutting deck is raised, the parking brake is
not activated and the driver gets out of the seat.
Check daily that the safety system is in working
order by attempting to start the engine when one of
the above conditions has not been met. Change
condition and try again.
ELECTriCAL SySTEM
Ignition and starter switch
Main Fuse
8042-116
8009-370
107
English-