Fitting The Hydrostatic Cable - Husqvarna Rider 316T/s AWD Workshop Manual

9. Remove the whole hydrostatic cable.

Fitting the Hydrostatic Cable

1. Screw the front link joint onto the new
hydrostatic cable and tension the locking
nut.
2. Feed the new cable through the mower
so it runs the same route as the old one.
3. Make sure the cable is pulled through the
cable bushing under the articulated
steering bearing. As illustrated.
rEPAir iNSTruCTiONS
Remove hydrostat cable
Front link joint
Insert cable
Under articulated steering bearing
6019-009
6019-018
6019-022
8009-737
69
English-