Removing Blades With Bearings - Husqvarna Rider 316T/s AWD Workshop Manual

6. Screw out the two deck frame bolts.
7. Loosen the screws on the cutting cover.
Lift up the deck frame and extract the
cutting unit cover.
8. Loosen the spring tensioning the V-belt
and prise off the belt.
Assemble in reverse order.

removing Blades with Bearings

WArNiNG!
use gloves and protective goggles
when working on the cutting deck.
This cutting deck has the bearing housing
flange located on top of the deck cover.
1. Remove the cutting deck upper cover,
see "Changing Belt on Cutting Deck
Combi 94, Combi 103, Combi 112".
2. Loosen the spring tensioning the V-belt
and prise off the belt.
rEPAir iNSTruCTiONS
8042-246
8042-267
8042-247
8042-338
99
English-