Setting Parallelism And Cutting Height - Husqvarna Rider 316T/s AWD Workshop Manual

2. Put back the cutting height stay and the
belt. Tighten the belt with the belt
tensioner.
3. Fit the front cover.
4. Put the cutting height control to one of the
positions 1-7.

Setting Parallelism and Cutting Height

Parallelism and height must be adjusted when
a new cutting deck is fitted.
Starting point:
1. Check tire pressure 60 kPa / 0.6 bar /
9 PSI.
2. The cutting deck must be lowered on a
level surface.
3. The height adjustment lever must be set
to the lowest cutting height.
rEPAir iNSTruCTiONS
8042-055
8042-014
95
English-