Change Of Front Belt - Husqvarna Rider 316T/s AWD Workshop Manual

Change of Front Belt

Dismantling
Remove the entire belt as described below
when mounting the snow blade on the
machine.
1. Put the cutting deck into service position.
2. Prise the center belt off the center pulley.
The belt is slackened when the cutting
deck is raised.
3. Remove the front belt from the center
pulley and take it away.
Assembly
1. Lay the front belt in place from the front.
Pull it outside the impeller and inside the
idler pulley. Place it in the center pulley
top groove.
rEPAir iNSTruCTiONS
Service position
Belt routing
Impeller and idler pulley
8042-252
8009-684
8009-831
81
English-