Replacing The Hydraulic Pump Drive Belt - Husqvarna Rider 316T/s AWD Workshop Manual

replacing the Hydraulic Pump Drive Belt

removal
1. Remove the transmission cover.
2. Prise the belt off the belt tensioner.
3. Remove the belt guide for the center belt.
4. Prise off the center belt from the engine
belt pulley and pull out the rear part.
A used belt can be prised down. With
new belts, the center belt must be prised
off the front belt pulley and then it can be
pushed down from the engine belt pulley
so that the rear part can be pulled out.
78
English-
rEPAir iNSTruCTiONS
Transmission cover
Belt tensioner
Belt guide
Rear part of front belt
6021-030
8009-839
8009-736
8009-638