Husqvarna Rider 316T/s AWD Workshop Manual page 70

4. Press the cable sheath into the front
attachment in the center console.
5. Screw on the front hydrostatic cable
clamp. Press the link joint onto its
attachment and fit the locking spring.
6. Screw the link joint onto the rear part of
the hydrostatic cable. Screw 10-12 turns
so that the link joint is the correct length.
7. Pull the hydrostatic cable along the other
cables.
8. Lay the hydrostatic cable in place on the
rear casing bracket and fit the rear clamp.
9. Adjust the hydrostat cable as described
in "Hydrostat cable adjustment".
70
English-
rEPAir iNSTruCTiONS
Front attachment in center console
Front clamp
Rear link joint
Hydrostat cable adjustment
6019-023
6019-024
6019-025
8009-819