Husqvarna Rider 316T/s AWD Workshop Manual page 58

10. Release the parking brake cable from the
front axle.
11. Loosen the stop screws (2x) and remove
the bearing on the right.
Assembly
1. Reassemble the front axle in reverse
order in relation to removal. Tighten the
left side bearing before the right side
bearing.
2. The stop screws for the right side bearing
is tightened after the five screws holding
the front axle have been tightened.
3. The synchronizing link is fitted in the
upper hole. (There is a hole for the clutch
control under the hole for the
synchronizing link)
58
English-
rEPAir iNSTruCTiONS
Rear front axle bracket
Parking brake cable
Right front axle bearing
Synchronizing link
8009-829
8009-691
8009-625
8042-121