Rear Axle - Husqvarna Rider 316T/s AWD Workshop Manual

4. Lightly oil in the pipe couplings before
assembly.
5. Grease the axles with corrosion
protection before fitting the wheels.
6. The spacer sleeves inside the wheels
have different lengths.
Left 36.3 mm + washer
Right 45.5 mm, no washer
Do not get mixed up with the rear axle spacer
sleeves.
7. Fill with oil and bleed the entire hydraulic
system as described in "Bleeding the
drive system".
8. Check and adjust the parking brake
cable.
9. Check and adjust speed coordination
between the front wheels and rear
wheels as described in separate
instructions.

rear Axle

removal
1. Raise and support the machine.
2. Remove the rear wheels.
• Remove the protective cover.
• Remove the circlip.
• Pull off the wheel and hub from the axle.
• Take hand of the key, spacer sleeve and
washers, keep track of the number of
washers, can vary between sides.
rEPAir iNSTruCTiONS
Supporting
Circlip
8009-651
8009-825
59
English-