Removing The Swing Axle - Husqvarna Rider 316T/s AWD Workshop Manual

11. Remove the inner circlip (1) from the
lower bearing (see illustration). The rear
carriage is now loose and can be moved.
Then take loose the outer circlip (2) and
take out the bearing from below.
12. Take out the upper bearing from above, if
it is stuck tap it from below.
13. Fit the new bearings and assemble the
articulated steering in reverse order to
removal.
14. Check the tension of the cable after
assembly, See "Checking and adjusting
the steering cables".
Also check that the control and cables
are correctly adjusted, see "Hydrostat
cable adjustment".
15. Bleed the hydraulic system. Top up with
oil after the test drive

removing the Swing Axle

1. Put supports under the machine in front
of the rear frame.
2. Clean, see "Working Methods".
52
English-
rEPAir iNSTruCTiONS
Lower bearing
Upper bearing
Supporting
6012-027
6012-028
6012-029