Installing A Removable Media Drive - Silicon Graphics 320 Owner's Manual

Installing a Removable Media Drive

1. Shut down the system and turn off the power. For detailed
instructions, see "Shutting Down the System" on page 12.
2. Unplug the power cord from the back of the system.
3. Remove the side and front covers.
For detailed instructions, see "Removing the Side Cover" on
page 16 and "Removing the Front Cover" on page 18.
4. If necessary, set the jumpers on the drive. To set the jumpers, refer
to the labeling on the back of the drive or to the documentation
that came with the drive.
If you are installing a floppy disk drive in the top 3 1/2" bay,
you do not need to set any jumpers. Go to step 5.
If you are installing a drive in the bottom 3 1/2" bay, set the
drive jumpers to Slave.
If you are installing a drive in the 5 1/4" bay, set the drive
jumpers to Master.
Internal Drives 33