Installing Or Removing The Dvd-Rom Drive; Installing The Dvd-Rom Drive - Silicon Graphics Tezro Hardware User's Manual

Installing or Removing the DVD-ROM Drive

Installing the DVD-ROM Drive

007-4564-001
The Silicon Graphics Tezro visual workstation supports an internal DVD-ROM drive
which is installed in the 5.25-in. drive bay. This drive bay is located on the upper left
portion of the front of the enclosure. The following sections contain instructions for
installing and removing the DVD-ROM drive:
• "Installing the DVD-ROM Drive" on page 71
• "Removing the DVD-ROM Drive" on page 74
Note: If you have not already done so, prepare your system for service. Refer to
"Preparing the Workstation for Service" on page 49. In order to install or remove the
DVD-ROM drive, you must remove the left side panel and the drive shroud. You do not
need to remove the entire bezel.
Follow these steps to install the DVD-ROM drive:
Note: You must remove the drive shroud before you can install the DVD-ROM drive.
1. Remove the plastic drive blanking plate that covers the DVD-ROM drive opening in
the drive shroud. Then remove the metal blanking plate that covers the front of the
DVD-ROM drive cage.
2. Attach the 5.25-in. drive rails to the sides of the drive by inserting the pins into the
openings in the sides of the drive (see Figure 3-13).
Installing or Removing the DVD-ROM Drive
71