Verifying And Troubleshooting Removable Media; Drive Installation - Silicon Graphics 320 Owner's Manual

10. Replace the front and side covers.
For detailed instructions, see "Replacing the Front Cover" on
page 20 and "Replacing the Side Cover" on page 21.
11. Reattach the power cord.
12. Turn on the system. For detailed instructions, see "Turning On
the System" on page 11.
Verifying and Troubleshooting Removable Media Drive
Installation
You can check to make sure the system recognizes the drive by
selecting Start > Programs > Administrative Tools > Disk
Administrator from the Windows NT task bar. See the Help in the
Disk Administrator for information on using it.
If the system does not recognize the drive, shut down and reopen the
system. Then:
• Check to make sure the power and ribbon cables are correctly
attached to the back of the drive (see Figure 4-1).
• Check the jumpers on the drives to verify they are set to Slave for
a drive in the bottom 3½" bay and to Master for a drive in the
5¼" bay.
Close and reboot the system. If the system still does not recognize the
drive, either the drive or a cable may be faulty. Contact your support
representative.
Internal Drives 37