Installing An Internal Hard Drive; Figure 4-10 Disconnecting Cables From An Internal Hard Drive - Silicon Graphics 320 Owner's Manual

40 Chapter 4
8. Replace the front and side covers.
For detailed instructions, see "Replacing the Front Cover" on
page 20 and "Replacing the Side Cover" on page 21.
9. Reattach the power cord.
10. Turn on the system. For detailed instructions, see "Turning On
the System" on page 11.

Installing an Internal Hard Drive

1. Shut down the system and turn off the power. For detailed
instructions, see "Shutting Down the System" on page 12.
2. Unplug the power cord from the back of the system.
3. Remove the side cover. For detailed instructions, see "Removing
the Side Cover" on page 16.
4. If any hard drives are currently installed, disconnect the cables
from the backs of the drives, as shown in Figure 4-10.
If you have internal SCSI drives installed, see "Disconnecting the
SCSI PCI Option Card Internal Cable" on page 52 for information
on disconnecting the SCSI cable from these drives.

Figure 4-10 Disconnecting Cables from an Internal Hard Drive