Verifying And Troubleshooting Internal Hard Drive; Installation - Silicon Graphics 320 Owner's Manual

Verifying and Troubleshooting Internal Hard Drive

Installation

You can check to make sure the system recognizes the drive by
selecting Start > Programs > Administrative Tools > Disk
Administrator from the Windows NT task bar. See the Help in the
Disk Administrator for information on using it. (To see SCSI devices,
select Start > Control Panel, double-click SCSI Adapters, then click the
+ next to PCI SCSI Card.)
If the system does not recognize the drive, shut down and reopen the
system. Then:
• Make sure the power and ribbon cables are correctly attached to
the back of the drive (see "Configuration and Cabling for Internal
Ultra33 EIDE Drives" on page 32 for EIDE drives).
• Make sure the jumpers are correctly set.
• If you have internal SCSI drives, make sure the drives have
unique ID assignments.
Close and reboot the system. If the system still does not recognize the
drive, either the drive or a cable may be faulty. Contact your support
representative.
Internal Drives 45