Figure 7-8 Removing The Fan - Silicon Graphics 320 Owner's Manual

4. Remove the fan, as shown in Figure 7-8.
Disconnect the fan power cable from the system board.
Push the tab on the edge of the fan inward and pull the fan
out of the system.
Removing the Fan
Figure 7-8
5. If you're not replacing the fan right away, replace the side cover.
For detailed instructions, see "Replacing the Side Cover" on
page 21.
Do not run the system without a working fan
Caution:
installed. The system may overheat and damage
the system board or other internal parts.
Power Supply and Fan 87