Disabling And Enabling The Password; Figure 8-1 Password Jumper; Figure 8-2 Password Jumper In Disabled Position - Silicon Graphics 320 Owner's Manual

Disabling and Enabling the Password

If you do not know your password, you can disable it by moving a
jumper on the system board.
1. Shut down the system and turn off the power. For detailed
instructions, see "Shutting Down the System" on page 12.
2. Unplug the power cord from the back of the system.
3. Remove the side cover. For detailed instructions, see "Removing
the Side Cover" on page 16.
4. Locate the password jumper just above the PCI card slots on the
system board, as shown in Figure 8-1.
Password
jumper
Figure 8-1 Password Jumper
5. To disable the password, move the jumper to the two rightmost
pins, as shown in Figure 8-2.
Figure 8-2 Password Jumper in Disabled Position
Maintenance and Troubleshooting 95