Figure 8-3 Password Jumper In Enabled Position - Silicon Graphics 320 Owner's Manual

96 Chapter 8
6. Reattach the power cord.
7. Turn on the system. For detailed instructions, see "Turning On
the System" on page 11.
8. Enter a new password when prompted to do so.
9. Shut down the system and remove the power cord from the back
of the system.
10. Move the jumper to the two leftmost pins, as shown in Figure 8-3.
Then reattach the power cord, replace the side cover, and power
up the system.
Your new password is now enabled.
Figure 8-3 Password Jumper in Enabled Position