Figure 3-10: Configure Snmp - Compaq StorageWorks SAN Director 64 Installation Manual

3–12 SAN Director 64 Installation Guide
Figure 3–10: Configure SNMP
a. For each trap recipient, type a community name of 32 or fewer alphanumeric
characters in the associated Community Name field. The community name is
incorporated in SNMP trap messages to prevent unauthorized viewing or use.
b. Click the checkbox in the Write Authorization column to enable or disable write
authorization for the trap recipient (default is disabled). A check mark in the box
indicates write authorization is enabled. When the feature is enabled, a
management workstation user can change sysContact, sysName, and sysLocation
SNMP variables.
c. Type the IP address or DNS host name of the trap recipient (SNMP management
workstation) in the associated Trap Recipient field. Use 64 or fewer alphanumeric
characters. Compaq recommends using the IP address.
d. The default UDP port number for trap recipients is 162. To override this port
number, click the Advanced option. The dialog box expands to show a UDP Port
Number column.
e. Type a decimal port number in the associated UDP Port Number field to override
the default value.
4. Click the Activate button to save the information. The message "Your changes to the
SNMP configuration have been successfully activated" appears.