Install Sdcm Client On A Remote Workstation - Compaq StorageWorks SAN Director 64 Installation Manual

2–66 SAN Director 64 Installation Guide
Sun Microsystems UltraPARC-II processor with a 300 MHz or greater clock speed,
using the SunOS Version 5.5.1 or higher operating system, or Solaris Version 2.5.1
or higher operating system.
IBM PowerPC microprocessor with a 233 MHz or greater clock speed, or
POWER3 microprocessor with a 333 MHz or greater clock speed, using the AIX
Version 4.3.3 or higher operating system.
At least 15 MB available on the internal hard drive.
32 MB or greater RAM.
Video card supporting 256 colors at 800 x 600 pixel resolution.
Ethernet network adapter.
Java-enabled Internet browser, such as Microsoft Internet Explorer (Version 4.0 or
later) or Netscape Navigator (Version 4.0 or later).
IMPORTANT: In order for SDCM to function properly, compatible versions must be installed on
both the client and server machines.

Install SDCM Client on a Remote Workstation

Use these steps to install SDCM on a remote client.
1. Verify the workstation and the Ethernet LAN segment (with the SAN Director 64
attached) are connected through the Internet.
2. At the workstation, launch the browser application.
3. At the browser, type the SDCM Server IP address.
4. The SDCM splash screen displays with the following options, see
a. Install SDCM Manager remote client application—select this option to install the
application for your workstation platform.
Figure 2–44.