Activate Or Deactivate Alerts; Delete Alerts - Compaq StorageWorks SAN Director 64 Installation Manual

2–62 SAN Director 64 Installation Guide
7. Make appropriate changes, then continue through the Modify Threshold screens,
making changes as necessary, until the summary screen appears displaying the alert
configuration.
8. Perform either of the following steps:
• If you need to change any parameters, select Previous and Next to display the
desired Modify Threshold screen.
• Select Finish when you are done.

Activate or Deactivate Alerts

Use the following steps to activate or deactivate existing threshold alerts. In the active
state, notifications are generated for the alert. In the inactive state, notifications do not
occur.
1. At the Hardware View for the selected director, select Threshold Alerts from the
Configure menu.
The Configure Threshold Alerts dialog box displays. The port's current state, inactive
or active, is listed under the State column.
2. To change the state, select the alert by the alert information in the table.
3. If the alert is active, select Deactivate to change to the inactive state. If the alert is
inactive, select Activate to change to the active state.

Delete Alerts

Use the following steps to delete existing threshold alerts.
1. At the Hardware View for the selected director, select Threshold Alerts from the
Configure menu.
The Configure Threshold Alerts dialog box displays.
2. Select the alert that you want to delete by selecting the alert information in the table.
3. Select Delete.
A message displays asking you to confirm the deletion.
4. Select Yes. The alert is removed from the dialog box.