Prepare The Switch For Install - Compaq StorageWorks SAN Director 64 Installation Manual

NOTE: Consider leaving the bottom and top U positions open to permit easy accessibility to the
cables entering and exiting the cabinet.
4. Position the higher, shelf bracket threaded hole in this square opening. See
5. Orient the shelf bracket in the rails.
6. Place the square washer provided on the front of the rail so that the two bumps on the
washer sit in opposite corners in the rail's square hole.
7. Insert the panhead Phillips screw, and partially tighten to temporarily stabilize the
bracket.
8. Make sure the shelf bracket is level, and align the rear of the shelf bracket with the
appropriate position on the rear rail See
9. Repeat steps 4 through 7 for the rear end of the shelf bracket.
10. Repeat steps 1 through 9 for the second shelf bracket.
11. Completely tighten all screws attaching shelf brackets to the rack's rails.
12. Using a torque driver, torque the screws to 22 in.- lbs.

Prepare the Switch for Install

The following section describes how to install the mounting hardware that attaches the
switch to the rails. This hardware includes:
Two front mounting brackets
Two rear mounting plates
Ten cage nuts
Eight screws
Installing and Configuring the SAN Director 64
Figure 2–2.
2–9
Figure 2–2.