Compaq Nc3123 Fast Ethernet Nic Pci 10/100 Wake On Lan Controller - Compaq ProLiant ML570 Maintenance And Service Manual

Compaq NC3123 Fast Ethernet NIC PCI 10/100
Wake on LAN Controller
To remove the Compaq NC3123 Fast Ethernet NIC PCI 10/100 Wake on LAN
(WOL) controller:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the access panel. See "Access Panel (Tower and Rack)" earlier in this chapter.
3. Disconnect the RJ-45 connector from the rear of the NC3123 controller.
4. Press the release tab
5. Swing open the expansion slot latch
6. Lift the controller
Figure 2-35. Removing an NC3123 Fast Ethernet NIC PCI 10/100 Wake on LAN (WOL) controller
Reverse steps 1 through 6 to replace an NC3123 Fast Ethernet NIC PCI 10/100 WOL controller.
on the expansion slot latch.


to unlock the controller.

out of the system board expansion slot.

3
Removal and Replacement Procedures 2-45
1
2