Configure Snmp Trap Message Recipients; Figure 2-32: Configure Snmp Dialog Box - Compaq StorageWorks SAN Director 64 Installation Manual

2–50 SAN Director 64 Installation Guide

Configure SNMP Trap Message Recipients

Use this procedure to configure community names, write authorizations, and network
addresses for up to 12 SNMP trap message recipients. A trap recipient is a management
workstation that receives notification through SNMP.
1. At the Hardware View for the selected Director, click the Configure icon at the
navigation control panel and select SNMP Agent from the pop-up menu. The
Configure SNMP dialog box displays. See
Figure 2–32: Configure SNMP dialog box
a. For each trap recipient to be configured, type a community name of 32 or fewer
alphanumeric characters in the associated Community Name field. The community
name is incorporated in SNMP trap messages to ensure against unauthorized
viewing or use.
b. Click the checkbox in the Write Authorization column to enable or disable write
authorization for the trap recipient (default is disabled). A check mark in the box
indicates write authorization is enabled. When the feature is enabled, a
management workstation user can change the SDCM Server's sysContact,
sysName, and sysLocation SNMP variables.
c. Type the IP address or DNS host name of the trap recipient (SNMP management
workstation) in the associated Trap Recipient field. Use 64 or fewer alphanumeric
characters. Compaq recommends using the IP address.
d. The default user datagram protocol (UDP) port number for trap recipients is 162.
To override this port number, click the Advanced button. The dialog box expands
to show a UDP Port Number column. See
Figure 2–32.
Figure 2–33.