Figure 2-5: Securing The Rear Angle Brackets - Compaq StorageWorks SAN Director 64 Installation Manual

4. Repeat steps 2 and 3 for the corresponding rear angle bracket. See
Figure 2–5: Securing the rear angle brackets
5. The two rear angle brackets now touch the outside surfaces of the rear mounting plates.
Slide the switch all the way into the rack to where the front mounting bracket meets the
rack rails.
6. If you are certain that the hardware lines up properly, secure the hardware as follows.
a. Secure each rear mounting plate to the rear angle bracket with the two screws
provided.
b. Move to the front of the switch, and secure each front mounting bracket with the
three screws provided.
7. Using a torque driver, torque the screws to 22 in. - lbs.
Installing and Configuring the SAN Director 64 2–13
Figure 2–5.