Install The Shelf Brackets In The 9000 Series Rack; Figure 2-2: Securing Shelf Brackets - Compaq StorageWorks SAN Director 64 Installation Manual

2–8 SAN Director 64 Installation Guide

Install the Shelf Brackets in the 9000 Series Rack

Use these steps to install the two shelf brackets in the rack.
1. Determine the appropriate placement for the switch inside the rack. It is important to
consider the number of switches you intend to install. See "Tips for Installing More
than One Switch," listed previously in this chapter.
2. Locate the small, round marker hole on the rails that coincides with the location
selected in step1. Each marker hole delineates the beginning of one rail unit, or U.
3. Locate the square opening in the rail that corresponds with the appropriate marker
hole. See
3
1 Marker hole
2 Square opening in rail
Figure 2–2: Securing shelf brackets
Figure 2–2.
1
2
4
3 Screws with captive lock and flat washers
4 Square alignment washers
SHR-2265B