2–20
SAN Director 64 Installation Guide
LAN-Connect the Director
Use these steps to connect the rack-mounted Director to the Ethernet LAN segment.
1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP card. See
Figure
1
Remote workstation
2
Ethernet hub or switch (customer supplied)
Figure 2–9: LAN-connect the Director
2. Connect the remaining end of each Ethernet cable to the LAN as directed by the
customer's network administrator.
NOTE: If an SDCM Server is not available, use the Embedded Web Server (EWS) interface.
Attach the Ethernet LAN segment to an Internet connection and refer to Chapter 3, "Using EWS
to Configure the Director."
2–9.
3
SDCM Server
4
SAN Director 64