Install The Sdcm Server Hardware Kit In A Rack; Figure 2-10: Sdcm Server Hardware Kit Components - Compaq StorageWorks SAN Director 64 Installation Manual

2–22 SAN Director 64 Installation Guide
1 Bottom Tray
2 Zip Drive AC Adapter
3 Laptop AC Adapter
Figure 2–10: SDCM Server Hardware Kit components

Install the SDCM Server Hardware Kit in a Rack

Complete the following steps to install the SDCM Server Hardware Kit into a
Compaq 9000 Series, or comparable rack.
NOTE: The SDCM Server Hardware Kit installs in most racks, using the supplied adjustable rail
extension. For example, the kit accommodates both the Compaq 9000 Series and
Compaq M Series racks.
1. Select an appropriate location to install the kit in the rack. The SDCM Server
Hardware Kit requires approximately 2.25 in. or 1.3U of space in the rack. Install the
kit one hole higher than the standard 1U location.
NOTE: If installing three or more switches, Compaq recommends installing the SDCM Server
and shelf in the middle of the rack.
4 Zip Drive
5 SDCM Server
6 Sliding Shelf