Configure Snmp Trap Message Recipients - Compaq StorageWorks SAN Director 64 Installation Manual

4. Update the address resolution protocol (ARP) table as follows.
a. Select the Close option from the File menu. The Windows desktop displays.
b. At the Windows desktop, click the Start button at the left side of the task bar. The
Windows Workstation menu displays.
c. At the Windows Workstation menu, select Programs > Accessories > Command
Prompt. A disk operating system (DOS) window displays.
d. Delete the Director's old IP address from the ARP table. At the command (C:\)
prompt, type arp -d xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the old IP address
for the SAN Director 64.
e. Click the close button [X] at the upper right corner of the DOS window to close the
window.

Configure SNMP Trap Message Recipients

Use this procedure to configure community names, write authorizations, and network
addresses for up to 12 SNMP trap message recipients. A trap recipient is a management
workstation that receives notification (through SNMP) if a Director event occurs.
1. Launch EWS. See the steps listed in the "Launch EWS" section at the beginning of
this chapter.
2. If network information was configured at the browser, go to step 3. If network
information was not configured, select the Configure option at the left side of the
panel. The Configure panel opens with the Ports page displayed.
3. At the Configure panel, click the SNMP tab. The SNMP page displays with Standard
selected. See Figure 3–10.
Using EWS to Configure the Director 3–11