Synchronize Date And Time; Frequently Used Sdcm Settings - Compaq StorageWorks SAN Director 64 Installation Manual

Synchronize Date and Time

Use these steps to set the Director to periodically synchronize date and time with SDCM.
1. At the Configure Date and Time dialog box, click the Periodic Date/Time
Synchronization checkbox to select the option (check mark in the box). The Date and
Time fields are greyed-out and not selectable.
2. Click Activate to enable synchronization and close the Configure Date and Time
dialog box. The Director date and time synchronize with the SDCM date and time at
the next update period (at least once daily).
3. Click the Sync Now button to synchronize the Director and SDCM immediately. The
Date and Time Synced dialog box displays.
4. Click OK.
5. Click Activate to enable synchronization and close the Configure Date and Time
dialog box.

Frequently Used SDCM Settings

This section summarizes the most common SDCM tasks, as follows.
NOTE: For a complete reference on SDCM functionality, refer to the Compaq SANworks Director
Connectivity Manager User Guide.
Set the director online
Set the director offline
Configure director identification
Configure operating mode
Configure operating parameters
Configure ports (Open Systems Mode)
Configure SNMP Trap message recipients
Configure and enable email notification
Configure director ports
Configure and Enable Call-Home
Configure threshold alerts
Enable EWS
Enable telnet
Installing and Configuring the SAN Director 64 2–43