Secure The Mounting Hardware; Figure 2-3: Securing The Two Mounting Brackets - Compaq StorageWorks SAN Director 64 Installation Manual

2–10 SAN Director 64 Installation Guide

Secure the Mounting Hardware

Use these steps to secure the mounting hardware to the switch.
1. Locate the two front mounting brackets in the shipping carton.
2. Secure the front mounting brackets on either side of the switch as shown in
For each front mounting bracket, use two flathead countersunk Phillips screws (10/32
x 0.25-inch) provided.
Figure 2–3: Securing the two mounting brackets
3. Using a torque driver, torque the screws to 22 in.- lbs.
4. Locate the two rear mounting plates in the shipping carton.
5. Secure the two rear mounting plates to each side of the switch as shown in
For each plate, use two flathead countersunk Phillips screws (10/32 x 0.25-inch)
provided.
6. Using a torque driver, torque the screws to 22 in.- lbs.
Figure 2–3.
Figure 2–3.