Grounding Methods - Compaq StorageWorks SAN Director 64 Installation Manual

C–2 SAN Director 64 Installation Guide

Grounding Methods

There are several methods for grounding. Use one or more of the following methods when
handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded workstation or computer
chassis. Wrist straps are flexible straps with a minimum of 1 megohm ± 10 percent
resistance in the ground cords. To provide proper ground, wear the strap snug against
the skin.
Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on
both feet when standing on conductive floors or dissipating floor mats.
Use conductive field service tools.
Use a portable field service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have a Compaq
authorized reseller install the part.
NOTE: For more information on static electricity, or for assistance with product installation,
contact your Compaq authorized reseller.