Compaq StorageWorks SAN Director 64 Installation Manual page 112

4–2 SAN Director 64 Installation Guide
Configuration data for the Director is stored in nonvolatile RAM on the CTP card and
is backed up through SDCM. The data is recorded in the SDCM data directory each
time a backup occurs.
The QuikSync application does not back up Windows NT operating system data, such as
NT user names, passwords, PC date and time, and TCP/IP network information. This
information was recorded while performing several installation tasks. See the "Record or
Verify SDCM Server Restore Information" section in this chapter.
1. Insert a blank Zip disk into the SDCM Server's external Zip drive.
2. Back up the Director configuration file to the SDCM Server. For instructions, refer to
"Back Up Configuration" section in this chapter.
3. If the Hardware View for the Director is open, click the Close icon and return to the
Product View.
4. Close SDCM. Click the Logout/Exit icon at the navigation control panel and select
Exit from the pop-up menu.
5. Use these steps to reboot the SDCM Server.
a. At the Windows NT desktop, click the Start button at the left side of the task bar,
then select Shut Down. The Shut Down Windows dialog box displays.
b. Select the "Restart the computer?" radio button and click Yes. The computer
powers down and restarts.
c. After the operating system starts, the Begin Logon dialog box displays.
d. Press Ctrl-Alt-Del. The Logon Information dialog box displays.
e. Type a Windows NT user name and password and click the OK button. The
Windows NT desktop opens and the SDCM Login dialog box displays.
NOTE: The default user name is Administrator and the default password is password. The user
name and password are case-sensitive.
f. Type the user name and password and select a SDCM Server from the SDCM
Server drop-down list.
g. Click the Login button. The Product View displays.