Figure 2-4: Aligning The Switch In The Rack - Compaq StorageWorks SAN Director 64 Installation Manual

2–12 SAN Director 64 Installation Guide
1. Carefully lift the switch into the front of the cabinet and onto the shelf brackets. Slide
the switch forward into the rack until the edge of the rear mounting plates are
approximately 1-inch from the rack's rails. See
Figure 2–4: Aligning the switch in the rack
2. Align one rear angle bracket with the cage nuts installed earlier, see "Inserting Cage
Nuts." See
NOTE: Make sure that the angle bracket is in contact with the outside surface of the
mounting plate.
3. Loosely attach the rear angle bracket to the rack rail with the two panhead Phillips
screws provided. See
Figure 2–5.
Figure 2–5.
Figure 2–4.