Table of Contents
Advertisement
2–16
SAN Director 64 Installation Guide
Changing the Director's IP Address
If multiple Directors are installed, or a public LAN segment is used, network addresses
must be changed to conform to the customer's LAN addressing scheme. The following
items are required to perform this task.
A local workstation (desktop or notebook computer) with:
Microsoft Windows 98, Windows 2000, Windows Millennium Edition, or
Windows NT 4.0 operating system.
RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal)
An asynchronous RS-232 null modem cable (supplied with the SAN Director 64).
Use the following steps to verify or change (if required) a Director's IP address, subnet
mask, or gateway address.
1. Remove the protective cap from the 9-pin maintenance port at the rear of the Director
(a flat-tip screwdriver may be required). Connect the 9-pin end of the RS-232 modem
cable to the port. See
Figure
2–7.
Advertisement
Table of Contents
