3–10
SAN Director 64 Installation Guide
2. At the Configure panel, click the Director tab, then select the Network option. The
Director page displays with Network selected as shown in
Figure 3–8: Configure Director, Network
a. At the IP Address field, type the new value as specified by the customer's network
administrator (factory preset is 10.1.1.10).
b. At the Subnet Mask field, type the new value as specified by the customer's
network administrator (default is 255.0.0.0).
c. At the Gateway Address field, type the new value as specified by the customer's
network administrator (default is 0.0.0.0).
3. Click the Activate button to save the information. See
Figure 3–9: Activate message box
Figure
3–8.
Figure
3–9.