Compaq StorageWorks SAN Director 64 Installation Manual page 42

2–18 SAN Director 64 Installation Guide
4. Configure the Port Settings parameters as follows:
Bits per second: 57600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware.
5. Click OK. The HyperTerminal window displays.
6. At the > prompt, type the user-level password (the default is password) and press the
Enter key. The password is case sensitive. The HyperTerminal window displays with
an SSP0> prompt at the top of the window.
7. At the SSP0> prompt, type ipconfig and press the Enter key. The HyperTerminal
window displays with configuration information listed as follows, see
MAC Address
IP Address (default is 10.1.1.10)
Subnet Mask (default is 255.0.0.0)
Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address fields are configurable.
Figure 2–8: