Enable Embedded Web Server; Enable Telnet; Connect The Cables To The Fibre Channel Ports; Figure 2-42: Connect The Fibre Channel Cables - Compaq StorageWorks SAN Director 64 Installation Manual

Enable Embedded Web Server

At the Hardware View for the selected director, select Enable Web Server from the
Configure menu. Selecting Enable Web Server automatically places a check mark in
the check box. Select Enable Web Server again to remove the check mark and disable
the EWS interface. When disabled, remote users cannot access the interface.

Enable Telnet

At the Hardware View for the selected director, select Enable Telnet from the
Configure menu. Selecting Enable Telnet automatically places a check mark in the
check box. Select Enable Telnet again to remove the check mark and disable telnet
access. When disabled, remote users cannot access the director through telnet.
Connect Cables to the Fibre Channel Ports
Use these steps to connect Fibre Channel port cables.
1. Route the fiber-optic cables from customer-specified devices to ports at the front of the
SAN Director 64. See
.
1
Director
2
Fibre Channel Cables
Figure 2–42: Connect the Fibre Channel cables
Installing and Configuring the SAN Director 64
Figure 2–42.
3
Workstation
2–63