Table of Contents
Advertisement
Chapter 3
Install the Chassis Cable - SmarTrax-Only
Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, etc.), it
is necessary to install the chassis power cable to operate the SmarTrax system. If a CAN system already exists
on the machine, refer to Connect SmarTrax to an Existing Chassis Cable (If Applicable) below to connect
power to the SmarTrax system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer for ordering information.
Locate the SmarTrax chassis cable (P/N 115-4001-085 or 115-4001-131).
1.
Connect the TO SMARTRAX NODE connector from the chassis cable to the round 16-pin connector on the
2.
node harness (P/N 115-4001-161).
Connect the TO CONSOLE CABLE connector to the Raven console cable.
3.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
4.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
5.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax system. Ensure the cable is
secured away from moving parts and heat sources.
Connect the ring terminals to the battery.
6.
Note:
The positive connectors are fused.
Note:
The chassis power cable can be connected to the cab's power strip using the supplied 3' power
strip cable (P/N 115-4001-164). The red wire is direct battery power, the orange wire is switched
power, and the black wire is ground.
Connect SmarTrax to an Existing Chassis
Cable (If Applicable)
Note:
The SmarTrax interface tee is sold separately. Contact your local Raven dealer for ordering
information.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
1.
machine's existing CAN system.
Install the SmarTrax interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and
2.
Raven console harness.
Connect the SmarTrax node cable (P/N 115-4001-161) to the remaining SmarTrax interface tee.
3.
Calibrate the SmarTrax System
Refer to the SmarTrax & SmartSteer Calibration & Operation Manual (P/N 016-0171-277) for instructions on
calibrating the SmarTrax system, adjusting system settings, and system operation.
16
John Deere 50/60/70 Series Combines - Steering Ready SmarTrax™ Installation Manual
Advertisement
Table of Contents
