Rear Panel Features And Cabling - Extron electronics RGB 580xi User Manual

Rear Panel Features and Cabling

100-240
50/60 Hz
RGB 580xi rear panel
1 AC power connector — Connect a standard IEC AC power
cord here for power input (100 VAC to 240 VAC, 50/60 Hz) to
the internal, autoswitching power supply.
2 BNC output connectors — Connect coaxial cables from a
display device to these BNCs for one RGBHV, RGBS, or
RGsB/RsGsBs video output as follows:
R G
RGBHV
3
Audio output connector — Cable an audio device to the
interface via this female 5-pole captive screw connector. Wire
the male connector as shown below.
NO Ground Here
NO Ground Here
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT
negative (-) contacts.
RS-232 connector — Connect an RS-232 device (control
4
system or PC computer) to this female 3-pole captive screw
connector for two-way RS-232 communication. Software for
RS-232 control is included with the interface. See chapter three,
3-pin RS-232 Captive Screw Con_lateral.eps
"Remote
control software and SIS commands. Wire the male connector as
shown below.
0.5A MAX.
R
1
B H/HV V
Tip
Sleeve(s)
Tip
Unbalanced Audio Output
connect the sleeve(s) to the
Control", for information on how to install and use the
Transmit
Receive
Ground
RGB 580xi • Installation and Setup
OUTPUTS
H
B
G
2
R G B H/HV
RGBS
Sleeve(s)
Do not tin the wires!
V
AUDIO RS-232
Tx Rx
3
V R G B
RGsB (Sync on Green)
RsGsBs
(output only if input is RsGsBs)
Tip
Ring
Tip
Ring
Balanced Audio Output
4
H/HV V
2-9