Table of Contents
Advertisement
25 Programming
25.3.1 Extended view
About this task
Steps
174
Planmeca Compact i
NOTE
The chair height cannot be programmed near the upper limit. The help code
H 8 is displayed if the chair position is not allowed. When needed, the upper
limit can be altered. Contact your Planmeca dealer.
NOTE
If you only want to rename the automatic position or adjust its position on the
list, start programming from step 4.
1. Move the chair to the required position by using the chair movement
buttons on the control panel or by using the foot control.
2. If you want the operating light or its composite mode to be on (off) in this
position, turn them on (off).
3. Adjust the intensity of the operating light and/or its composite mode as
described in section "Intensity" on page 190.
4. Press Program.
5. Press the Chair positions button.
A list of automatic positions opens.
6. Select the wanted chair position by pressing it on the list.
The field of the position that you have selected from the list (position C in
picture) turns blue.
User's manual
Advertisement
Table of Contents
Need help?
Do you have a question about the Compact i Touch v2 and is the answer not in the manual?
Questions and answers