Adjusting Intensity Of Operating Light - Planmeca Compact i Touch v2 User Manual

22.6.4 Adjusting intensity of operating light

From operating light
User's manual
NOTE
The dental unit can be configured so that you can switch the operating light's
composite mode on or off by pressing the Flexy button. Contact your
Planmeca dealer.
NOTE
The foot control can be configured so that the composite mode is switched
on/off when you push the left- or the right-side knob up. Contact your
Planmeca dealer.
The intensity adjustment range is from 30% to 100%.
Each time you adjust the intensity, the direction of the adjustment (increase/
decrease) changes. Thus, if you first increase the intensity, the intensity will
be decreased the next time you adjust it.
You will hear short successive clicking sounds while the intensity is being
adjusted and a long signal tone when the maximum/minimum intensity is
reached.
The operating light intensity can also be programmed, see section
"Planmeca Solanna and Planmeca Solanna Vision operating lights" on page
190.
NOTE
The operating light intensity will decrease to 30% of the maximum intensity
when the chair is moving.
NOTE
When the polymerisation light is taken from the holder and returned to it, the
composite mode is switched on. This feature is configurable; contact your
Planmeca dealer.
From one handle
Press and hold the handle button on either handle to adjust the intensity of
the operating light. The intensity increases/decreases for as long as you
press the button.
22 Operating dental unit
Planmeca Compact i 119