Industry Canada (Ic) Compliance Statement; Industrie Canada (Ic) Déclaration De Conformité; Rf Exposure - Planmeca Compact i Touch v2 User Manual

35 Certifications

35.5 Industry Canada (IC) Compliance Statement

35.6 Industrie Canada (IC) Déclaration de conformité

35.7 RF Exposure

302 Planmeca Compact i
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
Modifications: Any modifications made to this device that are not approved
by Planmeca may void the authority granted to the user by the FCC to
operate this equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This device has been tested for compliance with FCC RF exposure limits in
a portable configuration. At least 15 cm of separation distance between the
PlanID device and the user's body must be maintained at all times. This
device must not be used with any other antenna or transmitter that has not
been approved to operate in conjunction with this device.
User's manual