Automatic Chip Blow; Manual Chip Blow; Instrument Light - Planmeca Compact i Touch v2 User Manual

23.7.6 Automatic chip blow

23.7.7 Manual chip blow

23.7.8 Instrument light

User's manual
NOTE
The momentary spray can not be activated with the wide foot control pedal.
When the automatic chip blow is on, the indicator light on the control panel
button is on and two short blows of water, air, or both will occur after the
instrument is stopped.
Control panel: Press Chip blow to switch the automatic chip blow on or off.
NOTE
The foot control can be configured so that you push the left-side knob down
to switch the automatic chip blow on/off. Contact your Planmeca dealer.
NOTE
Check the indicator light on the control panel to verify that pushing the left-
side knob down activates the correct function.
The type of chip blow can be programmed, see section "Automatic chip
blow" on page 178.
Standard pedal: You can temporarily activate the manual chip blow by
pushing and holding down the pedal.
Wide pedal: You can temporarily activate the manual chip blow by pushing
and holding the pedal to the right.
The flow of air will continue until you remove your foot from the pedal.
NOTE
The type of manual chip blow does not depend on the type of the automatic
chip blow, but is always dry. The manual chip blow can be set to be
dependent on programming; contact your Planmeca dealer.
When the instrument light is on, the indicator light on the control panel button
is green.
Control panel: Press Instrument light to switch the instrument light on/off.
23 Operating instruments
Planmeca Compact i 157