3.8 Protection against electric shock
Ensuring protection against electric shocks when using DB1 variable
frequency drives, as per IEC/EN 61800-5-1
Manufacturer's declaration for the initial verification as per
IEC/HD 60364-6
(DIN VDE 0100-600 (VDE 0100-600)) and for periodic testing as per
EN 50110-1 (DIN VDE 0105-100 (VDE 0105-100))
Fault protection as per IEC/HD 60364-4-41 (DIN VDE 0100-410 (VDE 0100-410))
for the circuit on the output site of the aforementioned equipment is ensured
based on the following requirements:
•
The installation instructions in this documentation have been observed.
•
The applicable standards in the IEC/HD 60364 (DIN VDE 0100
(VDE 0100) series have been observed.
•
The continuity of all associated protective conductors and equipotential
bonding conductors, including the corresponding connection points, has
been ensured.
Provided that the above requirements are met, the aforementioned equip-
ment meets the requirements in IEC/HD 60364-4-41 (DIN VDE 0100-410
(VDE 0100-410):2007-06, section 411.3.2.5) when using the "automatic
power supply shutdown" protective measure.
The note is based on the following information:
In the event of a short-circuit with negligible impedance to a protective con-
ductor or to ground, the aforementioned equipment reduces the output volt-
age within the times as per Table 41.1 or otherwise within 5 seconds –
whichever applies – in accordance with IEC/HD 60364-41(DIN VDE 0100-410;
VDE 0100-410):2007-06).
DB1 Variable Frequency Drives 09/17 MN040031EN www.eaton.com
3.8 Protection against electric shock
3 Installation
65