User Guide - Xerox PrimeLink B9100 User Manual

Inserter Module
When the inserter tray is filled with 8.5 inch wide (SEF) media, its default size is 8.5" x 14". If you are
inserting 8.5" x 11" media, you must adjust the default of NVM 769-503 using Admin Mode Tools. For
additional instruction, refer to Xerox
Administrator Guide
To insert separator sheets or cover sheets, such as blank or pre-printed sheets, use the inserter tray T1.
Paper that is loaded in tray T1 is inserted into the finished or printed output. You can load a
maximum of 250 sheets in tray T1.
Tip: Paper fed from the inserter device is not printed on, but the paper is placed into the
printed output at selected locations.
1. Load the paper into tray T1. If the paper is pre-printed, load the paper with the printed side
facing up. Align all edges of the paper.
Note: To avoid possible paper jams or printer malfunctions, do not load paper above the
maximum fill line.
2. Grasp the center of the paper guides and gently slide the guides to the required paper size so
that the guides touch the edges of the paper.
Note:
• If the distance between the guides is too long or short for the paper, paper jams can
occur.
• If set by the system administrator, the Tray Properties screen appears on the printer
control panel.
3. From the Tray Properties screen, enter or verify the correct paper information.
4. To save the paper information and close the Tray Properties screen, touch OK.
316 Xerox ® PrimeLink

User Guide

® PrimeLink
® B9100/B9110/B9125/B9136 Copier/Printer
® B9100/B9110/B9125/B9136 Copier/Printer System