Xerox PrimeLink B9100 User Manual page 257

6. Move the rear edge of the paper to the position that corresponds to the skew amount.
• If the skew is oriented to the left, use the right-front edge of the paper as the pivot point.
• If the skew is oriented to the right, use the left-front edge of the paper as the pivot point.
Image
Skew is oriented to the left.
Skew is oriented to the right.
7. Tighten the four screws on the front-edge guide. To match the paper size, adjust the rear-edge
guide.
8. Rerun the Auto Alignment Adjustment procedure. Refer to the Xerox
B9125/B9136 Copier/Printer System Administrator Guide.
Rear-edge Guide Adjustment
Move the guides downward.
Move the guides upward.
Xerox ® PrimeLink ® B9100/B9110/B9125/B9136 Copier/Printer
Tray 5 (Bypass)
Front-edge Guide
Adjustment
Right side is higher. Left side is
lower.
Right side is lower. Left side is
higher.
® PrimeLink ® B9100/B9110/
User Guide
257