Huawei IDS1000-A Maintenance Manual page 128

IDS1000-A Air-Cooled Container Data Center
All-in-One Maintenance Guide
Procedure
Step 1 Switch off the circuit breaker for the access controller.
Step 2 Remove the access controller and mark cables, as shown in
Figure 5-37 Removing an access controller
1.
2.
3.
4.
5.
Step 3 Take out a new access controller, and set the IP address for the access controller by referring
to the management system initial configuration table.
Issue 01 (2016-01-10)
Remove the terminals on the right side of the access controller.
Remove the terminals on the left side of the access controller.
Remove the network cable on the top of the access controller.
Use a Phillips screwdriver to remove the four screws that fasten the access controller.
Remove the lower screws and then the upper ones.
Push the access controller upwards and remove it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
Figure 5-37.
120