Huawei IDS1000-A Maintenance Manual page 104

Air-cooled container data center

Table of Contents

IDS1000-A Air-Cooled Container Data Center

All-in-One Maintenance Guide

Procedure

Step 1 Locate the water sensor to be replaced based on the alarm information on the monitoring

software terminal.

Figure 5-15 Rope-type water sensor

Step 2 Remove the signal cable and extension cable, as shown in

Figure 5-16 Removing the signal cable

Step 3 Remove the screws tightening the faulty water sensor using a Phillips screwdriver, and

remove the water sensor.

Step 4 Install a new water sensor and tighten the screws.

Step 5 Connect the signal cable and extension cable for the water sensor in reverse order of

Step 6 Check that the new water sensor is working properly.

----End

Issue 01 (2016-01-10)

For the diagram and table, see the initial configuration guide.

Figure 5-15

Dip the water detection cable into water. If the monitoring software terminal generates an alarm, the

water sensor is working properly.

Huawei Proprietary and Confidential

shows a rope-type water sensor.

5 Parts Replacement

Figure

5-16.

Step

Table of Contents